Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plot the wall lift-off in viscous units on the ground only

Posted 15.06.2012, 11:35 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD), Results & Visualization Version 4.2a 1 Reply

Atit Koonsrisuk
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am simulating turbulent flow over buildings. After the computation finished, I want to see the numerical values of the 'wall lift-off in viscouse units' on the ground. One only thing that I can do, however, is that the 3D plot of 'wall lift-off in viscouse units' for all walls, which include the top wall, side walls. The vaules on the top and side walls are very much large (e.g. 1000). I want to examine if their numerical values all over the ground between 30-100.

Please suggest me how to do this.


Thank you.

Atit
1 Reply Last Post 15.06.2012, 14:10 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 15.06.2012, 14:10 GMT-4
Hi

you can dedouble your data set and add a selection list to it (to define only a few domains or boundaries or ...), then point the plot view to this new data set, or you add a filter node to your plot node and define a bolean condition over coordinates or domain id or ...

If you want to restrict the data or the display colors to a predefined range, you have this option in the lower plot nodes under one of the last tabs, you can also select line type, markers, position of markers, legend ...

--
Good luck
Ivar
Hi you can dedouble your data set and add a selection list to it (to define only a few domains or boundaries or ...), then point the plot view to this new data set, or you add a filter node to your plot node and define a bolean condition over coordinates or domain id or ... If you want to restrict the data or the display colors to a predefined range, you have this option in the lower plot nodes under one of the last tabs, you can also select line type, markers, position of markers, legend ... -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content