Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Adding interval from geometry toolbar

Posted 29.07.2019, 13:40 GMT-4 Battery Design, Geometry Version 5.3 1 Reply

Amit Shah
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am modelling the electrochemical impedance of a 1D li-ion battery, and would like to know how to add interval from the geometry toolbar. I am going through the tutorials by COMSOL for modelling impedance, but the geometry toolbar does not have "interval" in it.

1 Reply Last Post 31.07.2019, 16:32 GMT-4
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 31.07.2019, 16:32 GMT-4
Updated: 5 years ago 31.07.2019, 16:32 GMT-4

Hello Amit,

If you can update your installation to 5.4, you will find "Interval" in the Geometry toolbar when your geometry is 1D.

I don't have older versions on my machine to check if it was there at 5.3, but at least you can access the same functionality through the Model Builder by right-clicking on the Geometry node.

Best regards,

Jeff

-------------------
Jeff Hiller
Hello Amit, If you can update your installation to 5.4, you will find "Interval" in the Geometry toolbar when your geometry is 1D. I don't have older versions on my machine to check if it was there at 5.3, but at least you can access the same functionality through the Model Builder by right-clicking on the Geometry node. Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content