Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to calculate the eigenfrequency and eigenmodes of a solid structure with fluids inside?
Posted 16.12.2009, 23:05 GMT-5 1 Reply
Please login with a confirmed email address before reporting spam
I know the solid structure can be calculated by using the structure mechanics module and the fluid structure can be calculated by using the acoustics module. But how to couple the two modules and obtain the coupled eigenfrequency as well as eigenmode? Can anyone give some brief explanation or a small example?
Thanks a lot!
Thanks a lot!
1 Reply Last Post 26.12.2009, 00:03 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
I would try to build a driven frequency-domain simulation first (with a source), to test if the coupling works, and then switch analysis type in both application modes from frequency-response to eigenfrequency.
If either of the application modes you are using does not support eigenfrequency analysis, you should continue to use frequency-response analysis, but set the frequency (omega_something) of that application mode to "lambda*i" in Scalar Variables dialog. COMSOL defines eigenvalue variable "lambda" as -i*omega in most eigenfrequency analyses, so this would be consistent with the rest.
Then, choose Eigenvalue solver in Solver Settings and use it as you normally would. Make sure that the "Eigenvalue name" is set to "lambda" (in Solver Settings, Eigenvalue tab).
If either of the application modes you are using does not support eigenfrequency analysis, you should continue to use frequency-response analysis, but set the frequency (omega_something) of that application mode to "lambda*i" in Scalar Variables dialog. COMSOL defines eigenvalue variable "lambda" as -i*omega in most eigenfrequency analyses, so this would be consistent with the rest.
Then, choose Eigenvalue solver in Solver Settings and use it as you normally would. Make sure that the "Eigenvalue name" is set to "lambda" (in Solver Settings, Eigenvalue tab).