Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

comsol 3.5a[heat transfer module]problems with starting value

Posted 08.12.2009, 08:58 GMT-5 0 Replies

Luca Ferrario
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello
I have a problem with thermal module, I am not able to find T gradient. For example I have an aluminum desk and over it I have a steel object. I work with assembly and identity pair. I impose starting T for each objects (330K and 273 K) and heat flux for all boundaries. I make the mesh and i launch the simulation. The T distribution is a constant value of 330K. Where is the error?

Thank you in advance
Luca
0 Replies Last Post 08.12.2009, 08:58 GMT-5
COMSOL Moderator

Hello Luca Ferrario

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content