Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
The use of Permanent Magnet Synchronous Machines (PMSM) as shaft generators is not new in marine vessels propulsion drive trains. Due to risk of fires in stator windings by internal faults, DNV GL requires the shaft generator to be electrically dead without losing propulsion. This ... Mehr lesen
The determination of the constitutive equation of a nonlinear viscoelastic fluid is a challenging task, especially if a space-dependent equation is needed [1]. In this contribution, we present simulations of certain rheometry tests of a high-viscosity nonlinear viscoelastic fluid with a ... Mehr lesen
We present the results of full-waveform time-dependent finite-element modelling of coupled seismoelectromagnetic wave propagation in fluid-saturated porous media. To describe the seismoelectric response of the system a new set of equations is developed which couple the poroelasticity ... Mehr lesen
COMSOL Multiphysics® software was used to model radial source flow in two dimensional homogeneous porous media. Two-Phase Darcy's Law (tpdl) is used to model miscible viscous fingering. Fingering patterns obtained on using different mesh are discussed. Evolution from 'flowers' to ... Mehr lesen
Wear in hydrodynamic journal bearings resulting from solid contact in the mixed friction regime becomes an increasingly prominent topic leading to the necessity of numerical wear evaluations. A numerical method tackling this topic based on Archard’s wear law is presented and applied on a ... Mehr lesen
Surface discharge initiation and propagation on the surface of an insulating solid immersed in a dielectric liquid were examined numerically and experimentally. To establish a generalized numerical technique for evaluating surface discharge phenomena using the electrohydrodynamics (EHD) ... Mehr lesen
INTRODUCTION: Active cooling systems represent a possible solution to the electronics overheating that occurs in downhole tools operating on wireline, a cabling technology used to remotely control the downhole devices during oil and gas well interventions, in high temperature wells (150 ... Mehr lesen
In this paper, the "Morton Effect" is analyzed. This phenomenon is a particular kind of rotor instability due to non-uniform journal bearing heating. In this paper, an overview of the previous works has been done. After this preliminary study, a specific approach suggested by the ... Mehr lesen
In the Ball End Magneto rheological Finishing, due to heat generation by thermal agitation the effect of MRF finishing reduces and this ultimately hampers the process of the precision finishing and density of MR fluid too, which therefore results in instability of MR fluid. Mehr lesen
Recently, increasing availability of natural gas, due to the shale gas, raises the attention to the conversion of methane. Methanol-to-Hydrocarbons reaction (MTH) plays an important role in this route where methanol synthesized through syngas is converted into hydrocarbons, such as ... Mehr lesen