Sehen Sie, wie die Multiphysik-Simulation in Forschung und Entwicklung eingesetzt wird
Ingenieure, Forscher und Wissenschaftler aus allen Branchen nutzen die Multiphysik-Simulation, um innovative Produktdesigns und -prozesse zu erforschen und zu entwickeln. Lassen Sie sich von Fachbeiträgen und Vorträgen inspirieren, die sie auf der COMSOL Conference präsentiert haben. Durchsuchen Sie die untenstehende Auswahl, verwenden Sie die Schnellsuche, um eine bestimmte Präsentation zu finden, oder filtern Sie nach einem bestimmten Anwendungsbereich.
Sehen Sie sich die Kollektion für die COMSOL Conference 2024 an
In a water based electrolytic polishing process, the formation of molecular hydrogen at the cathode is unavoidable and it can contribute to the formation of surface defects at the anode side. This paper presents the work to model and simulate the molecular hydrogen flow inside radio ... Mehr lesen
Nitrogen oxides are one of the more dangerous ingredients contaminating the atmosphere. They are considered to be almost ten times more harmful than carbon monoxide, and sulfur dioxide several times. A whole range of photochemical reactions involving nitrogen oxides are responsible for ... Mehr lesen
This project makes a first attempt at modelling fluid flow over shark skin on a microscopic level. The modeled fluid flow shows good agreement with theory. Further refinement of the model parameters holds promises of better understanding of this complex fluid flow phenomenon. The COMSOL ... Mehr lesen
Wear in hydrodynamic journal bearings resulting from solid contact in the mixed friction regime becomes an increasingly prominent topic leading to the necessity of numerical wear evaluations. A numerical method tackling this topic based on Archard’s wear law is presented and applied on a ... Mehr lesen
Thermoelectric generators (TEG) use Seebeck’s effect to directly convert heat into electricity. TEG represent, therefore, a promising option for energy harvesting of waste heat, for example in car exhaust systems. To investigate the dynamic behavior of high temperature TEG, a test ... Mehr lesen
Highly loaded lubricated machine elements such as gears or camshafts are an integral part in a wide variety of technical products. Due to higher efficiency requirements these machine elements have to be improved continuously, which leads to the necessity to investigate physical ... Mehr lesen
Pervaporation is the selective evaporation of one component in a liquid mixture using a membrane. HybSi pervaporation membranes consist of porous ceramic support tubes with a thin selective layer on the inside or feed side. Modules for 7 and 19 membrane bundles (surface area up to 2.0 ... Mehr lesen
As known, air quality in urban areas is dramatically affected in particular by the noteworthy presence of respirable suspended particulate matter (such as PM2.5), nitrogen oxides (NOx), carbon monoxide (CO) and hydrocarbons (HC), which are mainly due to traffic-induced emissions. On the ... Mehr lesen
A wind tunnel experiment was modelled using COMSOL Multiphysics® CFD software. A k-ω coupled turbulence model was considered including the Brinkman equation for stationary air flow through a porous vegetation section. Mehr lesen
Aqueous polymers used for enhanced oil recovery (EOR) application is considered a complex fluid. It can exhibit Newtonian and Non-Newtonian behavior depending on the velocity or the stresses that it is submitted during the flooding process. Therefore, the polymer flooding project ... Mehr lesen