Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Limiting the Parametric Sweep study step to a specific step(s) in the study.

Posted 31.08.2015, 20:58 GMT-4 Studies & Solvers Version 5.0, Version 5.2a 2 Replies

Matthew Robinson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm doing a small signal analysis (stationary, freq-perturbation) and I want to run a parametric sweep (on geometry) for the stationary step only. I can't seem to figure out how to isolate this within the study. No matter what I do in the solver and job configs every time I run the study it always wants to run the sweep on the stationary and freq steps. This means it wants to do a parametric sweep for each frequency in my freq step, which obviously will take a long time.

Right now I've created two different studies to separate these, essentially running the stationary step twice. But is there anyway I can do this without having to solve the stationary step twice?
2 Replies Last Post 17.02.2017, 04:48 GMT-5
COMSOL Moderator

Hello Matthew Robinson

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Xu Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 19.01.2016, 12:39 GMT-5
Hi Matthew,
I have countered the same problem. Have you solved it?

Thanks,
Xu
Hi Matthew, I have countered the same problem. Have you solved it? Thanks, Xu
Ting-Wei Liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 17.02.2017, 04:48 GMT-5
Same problem.

I tried creating a new study for the step needs parametric sweeping.
And for the Values of Dependent Variables, call the solution in the previous study.
But it does not work. The result is still with zero initial value
Same problem. I tried creating a new study for the step needs parametric sweeping. And for the Values of Dependent Variables, call the solution in the previous study. But it does not work. The result is still with zero initial value

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content