Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

changing boundary conditions

Posted 10.08.2010, 11:57 GMT-4 0 Replies

Andras Gilicz
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear Ivar, dear COMSOL fans

I have a 1D porous media flow with the following bondary conditions:

@ x=0: p=p_in ; C1 * dp_in/dt = partialp/partialx
@ x=L: p=p_out ; C2 * dp_out/dt = -partialp/partialx

Because partialp/partialx is actually proportional to the in- and outflow fluid velocity, this can also be written:

@ x=0: p=p_in ; C1' * dp_in/dt = v_in
@ x=L: p=p_out ; -C2' * dp_out/dt = v_out

How can I specify this to COMSOL? Here p is the pressure in the porous medium, C1, C2, C1' and C2' are known constants. I use COMSOL V4 and the Earth Science module.

Any help, advise or example would be gratefully appreciated.
Tx in advance, best regards

Andras
0 Replies Last Post 10.08.2010, 11:57 GMT-4
COMSOL Moderator

Hello Andras Gilicz

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content