Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Combine "Electric Currents" and "Electric Currents, Shell"?

Posted 18.06.2015, 07:09 GMT-4 Low-Frequency Electromagnetics Version 5.0 0 Replies

Metin Celik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a Circuit Board which uses "Electric Currents, Shell". A thick Copper Bar is connected to the Circuit Board which I want to use "Electric Currents" (domain, not shell). I tried enhancing the "heating_circuit.mph" from the Model Library by adding "Electric Currents" and connecting an additional Domain to the circuit but I was not able to solve it.
Is it possible to have an electric current flow from a Domain to a Shell?

Edit: Actually I think I don't need to combine both physics because the current is always the same. So I can simulate them seperately.
0 Replies Last Post 18.06.2015, 07:09 GMT-4
COMSOL Moderator

Hello Metin Celik

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content