Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Another Meshing Problem of 2 thin geometries
Posted 16.07.2010, 07:40 GMT-4 1 Reply
Please login with a confirmed email address before reporting spam
Hi!
I have the problem of meshing 2 thin geometries which form a union. If I mesh only the main part, it works. but meshing with free tetrahedal both i get the error:
Failed to respect boundary element edge on geometry face.
If I perform an triangular mesh and swep it, i get the following error:
Unsupported topology of boundary face.
The problem is, to connect the mesh from the first part with the second part. If I swep, the connected part is in a different plane, so the mesh would´nt connect!?
Does anyone knows how to create the mesh and further avoid singularities?
Thanks!
I attached the file
kind regards,
Steve
I have the problem of meshing 2 thin geometries which form a union. If I mesh only the main part, it works. but meshing with free tetrahedal both i get the error:
Failed to respect boundary element edge on geometry face.
If I perform an triangular mesh and swep it, i get the following error:
Unsupported topology of boundary face.
The problem is, to connect the mesh from the first part with the second part. If I swep, the connected part is in a different plane, so the mesh would´nt connect!?
Does anyone knows how to create the mesh and further avoid singularities?
Thanks!
I attached the file
kind regards,
Steve
Attachments:
1 Reply Last Post 19.07.2010, 02:08 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hello!
Meanwhile I found a solution :-)
Meshing was possible by dividing the cross section in an upper and an lower part. So the narrow curve is interrupted an free meshing is possible!
kind regards,
Steve
Meanwhile I found a solution :-)
Meshing was possible by dividing the cross section in an upper and an lower part. So the narrow curve is interrupted an free meshing is possible!
kind regards,
Steve