Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Single Coil Gap Feed Problem
Posted 10.04.2015, 10:25 GMT-4 Low-Frequency Electromagnetics Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
Hii all,
I am trying to simulate a simple geometry and I am having problems in giving a particular value of current through the gap feed. The problem is the current density shows always zero.
Can someone help ? I have attached my model herewith.
www.dropbox.com/s/kktoh7c3rpxqam6/PCB_3Dmodel2.mph?dl=0
Thank you.
Regards,
Anup
I am trying to simulate a simple geometry and I am having problems in giving a particular value of current through the gap feed. The problem is the current density shows always zero.
Can someone help ? I have attached my model herewith.
www.dropbox.com/s/kktoh7c3rpxqam6/PCB_3Dmodel2.mph?dl=0
Thank you.
Regards,
Anup
1 Reply Last Post 13.04.2015, 06:32 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
10 years ago
Hi Anup,
as in your other forum post - the coil feature in your model did comprise more entities than needed,
thereby not creating a regular coil. See my suggestion.
I have deleted all solutions and meshes tho have the model small for transmission in the forum - it solves in 55s.
Best regards,
Sven
as in your other forum post - the coil feature in your model did comprise more entities than needed,
thereby not creating a regular coil. See my suggestion.
I have deleted all solutions and meshes tho have the model small for transmission in the forum - it solves in 55s.
Best regards,
Sven
Attachments: