Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Simulation of heat pipe
Posted 12.08.2014, 03:43 GMT-4 Fluid & Heat, Heat Transfer & Phase Change Version 4.3b 0 Replies
Please login with a confirmed email address before reporting spam
I encountered the following errors at the "corner nodes" of my geometry while trying to compute.
My boundary conditions are correct.The model runs fine with heat equation off.But when I include heat transfer equation , I am getting the error shown below.Kindly post suggestions to help me.I tried making mesh finer ,filleting etc,but could not solve the problem.Mine is an axisymetric problem.
Undefined value found.
- Detail: Undefined value found in the equation residual vector.
There are 95225 degrees of freedom giving NaN/Inf in the vector for the variable mod1.T.
at coordinates: (0,0.17), (0,0.16996), (2.72916e-005,0.169974), (3.94737e-005,0.17), (0.0015,0.17), ...
Hello ROHIT S NAIR
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.