Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Moving Mesh and Geometry

Posted 19.06.2014, 11:22 GMT-4 Heat Transfer & Phase Change, Geometry, Mesh, Results & Visualization Version 4.4 0 Replies

Kathleen Lewicki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I have been working on a model that simulates a small stationary cylindrical pin on a cylindrical puck that is moving in a square cyclical pattern to simulate frictional heating. The puck and pin are unioned together. I am using a moving mesh and translational motion for the cylindrical puck in HT to simulate this. When I look at the results and export an animation, the resulting "heat" appears to be moving in the correct pattern, however, the geometry does not move. If the geometry does not move, does that indicate that I have a problem with how I configured the moving mesh?

I included a .gif file of what I am seeing. Any thoughts or input would be helpful!

Thanks
Kathleen
0 Replies Last Post 19.06.2014, 11:22 GMT-4
COMSOL Moderator

Hello Kathleen Lewicki

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content