Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Editing of a composit object in draw mode of comsol

Posted 12.08.2009, 08:36 GMT-4 0 Replies

Michael Rembe Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

is there a good way to edit a composit object using comsol after creating a new geometry from a deformed mesh?

Is there a way to export/import geometry objects (such as composite objects) to/from dxf without any loss of model topology?

I use ALE to deforme my mesh. It works well but after some simulation periods I have to make some corrections to get a smooth contour again.

Thanks, best regards
MIchael
0 Replies Last Post 12.08.2009, 08:36 GMT-4
COMSOL Moderator

Hello Michael Rembe

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content