Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Symmetry in General Form PDE module
Posted 27.04.2014, 04:40 GMT-4 Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.4, Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
I am trying to simulate, let's say, two turns of the coil (current is flowing the same direction in both turns) in 2D case using a General Form PDE module. I have only copper windings surrounded by air. Instead of doing that, I would like to simulate only one turn (half of the model) because it is a symmetric case and simulation would be much faster. I do not know how to implement/use this symmetry in PDE module. Any suggestions?
Hello Rokas Bondzinskas
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I encountered the same issue. Did you solve it ?
Thank you,
Mhrz