Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

modelling two phase device

Posted 04.04.2014, 11:35 GMT-4 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 3.5a 0 Replies

Suhail Alhasani
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hii,

I have problem modelling a device. The device basically consists of two inlets and two outlet, in which one inlet is for the air, and the other one is for water, and the same is for the outlet.
The main purpose for the device is to check the interaction of both water, and air.
The problem here is that which module is suitable for this simulation. Please I need your help.

Thanks in Advance
0 Replies Last Post 04.04.2014, 11:35 GMT-4
COMSOL Moderator

Hello Suhail Alhasani

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content