Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mesh Control and Periodic Boundary Conditions
Posted 02.09.2013, 11:09 GMT-4 RF & Microwave Engineering, Geometry, Mesh, Modeling Tools & Definitions Version 4.3b 0 Replies
Please login with a confirmed email address before reporting spam
Are mesh control boundaries compatible with faces that are part of a periodic condition?
I have a mesh I'd like to optimize with the mesh control operations but so far I've noticed that if the mesh control operation has a face that lies on a periodic boundary the results become invalid - even though everything appears the same (geometry, periodic condition boundaries, mesh, etc.).
If I had to guess I'd say the periodic condition isn't being implemented in the mesh control face even when it resides entirely on a face that is in the periodic condition (you can't even see the mesh control face when selecting periodic boundaries).
Has anyone had success with using the mesh control operations with periodic boundaries?
-Frank
Hello Frank McDermott
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.