Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Dye oscillator, please help

Posted 10.05.2013, 12:37 GMT-4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 3.5a 0 Replies

Bogdan Dmytryshyn
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello! I model Dye oscillator ( rspa.royalsocietypublishing.org/content/155/886/498.full.pdf+html ) in Comsol. The frequency of a ring oscillator is supposed to be the wave speed through the quartz = ~5460 m/sec divide by (PI * diameter). In the original dimensions of 75.28 mm inside diameter, 98.6 mm outside diameter gives an average diameter of 86.94mm resulting in a 20 kHz fundamental mode. Why Comsol gives the results of 50Hz? Actual result from Dye oscillator also confirms 20kHz.
0 Replies Last Post 10.05.2013, 12:37 GMT-4
COMSOL Moderator

Hello Bogdan Dmytryshyn

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content