Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Postprocessing-visualization of symmetric profiles

Posted 11.04.2013, 13:43 GMT-4 Results & Visualization, Structural Mechanics Version 4.3a 1 Reply

John R Puentes
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I solved the thermal stresses in a plate using two faces of symmetry, saving computational cost. I wonder if COMSOL allows me to mirror the two symmetric faces and visualize the deformation in the full plate rather than in the quarter that I simulated.


Thanks
1 Reply Last Post 11.04.2013, 14:52 GMT-4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11.04.2013, 14:52 GMT-4
Hi

indeed at least in the most recent versions (as the one you quote, yuo can revolve a 2D-axi or extrude a 2D or mirror a 2D or 3D model, you do that under the Data Set node (right click+...) then you can add a specific higher dimension plot node and refer to your new data set

--
Good luck
Ivar
Hi indeed at least in the most recent versions (as the one you quote, yuo can revolve a 2D-axi or extrude a 2D or mirror a 2D or 3D model, you do that under the Data Set node (right click+...) then you can add a specific higher dimension plot node and refer to your new data set -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content