Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

coupling model, extrusion 2D-axy towards 3D

Posted 18.02.2013, 08:13 GMT-5 Parameters, Variables, & Functions Version 4.3a 3 Replies

Julien Givernaud
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

Is it possible to re-use temperature boundary results of a 2D-axy simulation towards a boundary destination of a 3D model (4.3a version)?

Which operator could I use if it's possible?

Thank you

Julien
3 Replies Last Post 20.02.2013, 02:53 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18.02.2013, 10:00 GMT-5
Hi

isnt that the projector operator you should use ? Check the doc

--
Good luck
Ivar
Hi isnt that the projector operator you should use ? Check the doc -- Good luck Ivar
Julien Givernaud
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 18.02.2013, 10:24 GMT-5
Thank you for the response Ivar

I have already chek the doc and tutorials but this case is not in the database
I don't know if it's possible to couple these boundaries

You think it is?
Thank you for the response Ivar I have already chek the doc and tutorials but this case is not in the database I don't know if it's possible to couple these boundaries You think it is?
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20.02.2013, 02:53 GMT-5
Hi

sorry it was the linear extrusion operator I meant, (the projection operator integrates over the third DoF) I posted an example on another thread today

www.comsol.eu/community/forums/general/thread/34882/#p96203

--
Good luck
Ivar
Hi sorry it was the linear extrusion operator I meant, (the projection operator integrates over the third DoF) I posted an example on another thread today http://www.comsol.eu/community/forums/general/thread/34882/#p96203 -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content