Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to track the values of the user defined variables

Posted 13.02.2013, 10:45 GMT-5 Heat Transfer & Phase Change, Results & Visualization Version 4.3a 2 Replies

Ning Tian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am working on simulation of the ignition of composite materials. And I want to track the values of the variables I defined in the simulation. Is there any way I can do that ?
2 Replies Last Post 13.02.2013, 16:08 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13.02.2013, 13:16 GMT-5
Hi

Check the doc and the nodes under "Definitions - Probes", this allows, with the solver node "Plot while solving" settings, to follow the results while solving. Do not forget the settings: for solver store steps, or all solver steps



--
Good luck
Ivar
Hi Check the doc and the nodes under "Definitions - Probes", this allows, with the solver node "Plot while solving" settings, to follow the results while solving. Do not forget the settings: for solver store steps, or all solver steps -- Good luck Ivar
Ning Tian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13.02.2013, 16:08 GMT-5
Thanks
Thanks

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content