Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary current source vs terminal - on internal boundary

Please login with a confirmed email address before reporting spam

Hello,

I have a question about the AC/DC module -> Electric currents.

I made a simple model and assigned a terminal boundary condition of 1A in one of the contact surfaces, which is an internal boundary in the model.

When I integrate the total current on the ground that comes very close to 1A.

However, when I replace the terminal with a boundary current source on the same internal boundary and replace 1A with 1A/(area of the contact in sq.m). The resultant electric field is much weaker and the total current on the ground is about 0.1, 10 timess less that what I applied.

I think this is strange because I expect both the conditions to deliver 1A current.

I appreciate any help in pointing out the error in this process.


0 Replies Last Post 13.02.2024, 15:00 GMT-5
COMSOL Moderator

Hello Aragorn

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.