Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Capillary filling changing area
Posted 02.12.2012, 16:39 GMT-5 0 Replies
Please login with a confirmed email address before reporting spam
I have been working on a simple 2-phase flow through a capillary. The next step in my model is for the fluid (water) to leave the capillary to a duct with a higher surface area.
The model solves the capillary part fine, and at the point of the area change just stops and gives the following error:
Nonlinear solver did not converge.
Time : 0.001617806971730043
Last time step is not converged.
Note: the exact model solved without any problems with just the capillary (before changing geometry)
Hello Doaa Dwidar
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.