Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

different results of simulating mechanical resonant frequency

Posted 16.10.2012, 18:16 GMT-4 Structural Mechanics 0 Replies

Suiqiong Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate the longitudinal (x axis) mechanical resonant frequency of a free standing beam. I set the constrain at y and z axis and did the simulation. However, even I keep every parameters and mashing same, the enginfrequency changes a little bit every time I re-solve the problem. Shouldn't the calculation results be same?

I also add a layer materials with different mass, and simulate the frequency change. However, after I add the layer, it always shows error message: "out of memory during assembly". I don't know how to solve the problem.

I am using COMSOL 3.4.

Please give my some help.
0 Replies Last Post 16.10.2012, 18:16 GMT-4
COMSOL Moderator

Hello Suiqiong Li

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content