Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Pressure effect in convection and diffusion model

Posted 10.02.2010, 09:35 GMT-5 0 Replies

chattarbir singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

I am solving the gas phase in a tube in convection and diffusion model. Where i enter the gas at certain pressure and outlet the pressure is atmospheric.

So it means with decrease in pressure along the length of tube the concentration of profile is decreasing.

Is it possible to see this effect with convection and diffusion model

Any suggestions would be appreciated
regards
chattarbirsingh
0 Replies Last Post 10.02.2010, 09:35 GMT-5
COMSOL Moderator

Hello chattarbir singh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content