Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
''Failed to find consistent initial values.' on Time Dependent mode only
Posted 09.07.2012, 20:23 GMT-4 Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to simulate a high velocity, high temperature air jet simulation on a refractory brick sample. I'm using the Conjugate heat transfer module to see and measure the effect. The simulation runs ok (well, not completely, I have a few errors, but I think those are negligible) on the stationery mode. But whenever I switch to Time Dependent mode, I always get the ''Failed to find consistent initial value" message. I don't know what's causing this because as far as I've checked, all the BCs are properly define. I've also experimented with a few combinations of different mesh types and initial values, but none of that is working. Perhaps someone can take a look at my model and suggest something.
Thanks.
PS: My model was done in COMSOL 4.2
Attachments:
Hello Naser Imran Hossain
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.