Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Internal error in geometry composition, Comsol 4.2a

Posted 03.07.2012, 11:10 GMT-4 1 Reply

Nikola Bralovic
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear Fellows,

I want to make blocks with round edges in 3D. I use standard procedure, I define workplanes, make geometrical objects in 2D, do "extrude", end on the end - INTERSECTION.

When I do these steps in Comsol 4.2a version 4.2.1.110 (older version) everything is OK, but when I do the same in

Comsol 4.2a version 4.2.1.166 (newer version) I receive message:

"Internal error in geometry composition"

Please if someone have a solution for this problem because I need to solve this in newer version because on workstation on which I work is the newer Comsol. I tried to make this module in older version and then to open it in newre version, but then I receive some message about problems with CAD import module.

Thanks in advanced.

1 Reply Last Post 16.08.2012, 06:46 GMT-4
COMSOL Moderator

Hello Nikola Bralovic

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Robin Kieser
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 16.08.2012, 06:46 GMT-4
this error often means that the programm doesnt like certain boundaries to touch/overlap with each other. just create a minimal gap between each geometric object to get it to work and then search stepwhise for the bugged area by removing the gaps one at a time
this error often means that the programm doesnt like certain boundaries to touch/overlap with each other. just create a minimal gap between each geometric object to get it to work and then search stepwhise for the bugged area by removing the gaps one at a time

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content