Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
boundary condition of solar radiation
Posted 26.06.2012, 01:12 GMT-4 Heat Transfer & Phase Change Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
hi...
I have some question about solar radiation model (external radiation source)
Applies to the wall of building, only one side of wall is applied the solar incident radiation.
I was modeling the wall as 2D (rectangle wall)
How should I set the boundary conditon of wall
1. only one side of wall ( solar incident radiation)
surface-surface radiation? or surface-ambient radiation?
2. others of wall
adiabatic? or surface-surface radiation? or surface-ambient radiation?
my geometry is in attached file
I have some question about solar radiation model (external radiation source)
Applies to the wall of building, only one side of wall is applied the solar incident radiation.
I was modeling the wall as 2D (rectangle wall)
How should I set the boundary conditon of wall
1. only one side of wall ( solar incident radiation)
surface-surface radiation? or surface-ambient radiation?
2. others of wall
adiabatic? or surface-surface radiation? or surface-ambient radiation?
my geometry is in attached file
Attachments:
1 Reply Last Post 26.06.2012, 02:32 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
the best is to check each one, read the help and look at the equations:
Heat flux gives an incident boundary (surface) flux in W/m^2 with some options
Convective cooling corresponds to the removal of heat by air convection (not that much different from the previous, but it "bins-in" the internal variables convection part)
Surface to ambient is for radiative exchange to a large outside domain at a given temperature
Inflow heat flux mimics a virtual domain
For solar flux, if I read the new 4.3 doc correctly you must turn on the surface to surface or re radiating surface check box this will add new items in the right-click list (was probably the case in 4.2 too )
--
Good luck
Ivar
the best is to check each one, read the help and look at the equations:
Heat flux gives an incident boundary (surface) flux in W/m^2 with some options
Convective cooling corresponds to the removal of heat by air convection (not that much different from the previous, but it "bins-in" the internal variables convection part)
Surface to ambient is for radiative exchange to a large outside domain at a given temperature
Inflow heat flux mimics a virtual domain
For solar flux, if I read the new 4.3 doc correctly you must turn on the surface to surface or re radiating surface check box this will add new items in the right-click list (was probably the case in 4.2 too )
--
Good luck
Ivar