Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Need help with Heat Transfer in Solid

Posted 20.06.2012, 18:26 GMT-4 Heat Transfer & Phase Change Version 4.2a 0 Replies

Tac Huynh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I tried to model a simple 3D heat transfer in solid problem of a steel heater embedded in aluminum block.
The solution never reach a conversion solution.
Investigate the model, looks like Added Heat Source 1 never get overriden in Thermal Insulation 1 but added Heat Flux 1 get overriden. in the Thermal Insulation 1.
Did I miss anything for this simulation?
Have any body run into this same problem?
Your help is appreciated.
Tac.
0 Replies Last Post 20.06.2012, 18:26 GMT-4
COMSOL Moderator

Hello Tac Huynh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content