Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
boundary condition
Posted 09.06.2012, 05:23 GMT-4 Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi
dear Mr evar
I did not understand for what the output voltage is not symmetrical
and what does not has a voltage of 1V is ready (as calculated theoretical value)?
Thank you.
dear Mr evar
I did not understand for what the output voltage is not symmetrical
and what does not has a voltage of 1V is ready (as calculated theoretical value)?
Thank you.
Attachments:
1 Reply Last Post 11.06.2012, 01:03 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
probably you have some parasitic capacity loss that offsets your signal, or could it be some low conductance ?
It seems to drift too, so have you taken the fall time ? and checked if its not a initial value transient ?
--
Good luck
Ivar
probably you have some parasitic capacity loss that offsets your signal, or could it be some low conductance ?
It seems to drift too, so have you taken the fall time ? and checked if its not a initial value transient ?
--
Good luck
Ivar