Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Need help in material activation and deactivation for simulation of SLM process.

Posted 24.05.2021, 02:37 GMT-4 Structural & Acoustics 0 Replies

Saim Abbas
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am not able to use the Material Activation and Deactivation for simulation of the SLM process. I was able to make a moving point heat source in comsol but, in order to do add material layer by layer I have to activate next layer and so on as is done in SLM process. I have not been able to do this so far on my own. Please help me, I will be really grateful.

0 Replies Last Post 24.05.2021, 02:37 GMT-4
COMSOL Moderator

Hello Saim Abbas

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content