Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Sweeping Mesh on a Cylinder in Comsol 5.4

Posted 08.05.2020, 18:04 GMT-4 Version 5.4 0 Replies

Rafael Sonderegger
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi I am new to Comsol and I am having trouble with the meshing of my geometry. I have a 2D-Axissymetrical cylinder. I want to define the Mesh at the inlet(lower edge) to be very fine, take that crossection and sweep it along the cylinder-axis.

I know there is the swept command for 3D components but is there a equivalent to that in the 2D Axissysmetrical ?

0 Replies Last Post 08.05.2020, 18:04 GMT-4
COMSOL Moderator

Hello Rafael Sonderegger

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content