Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

QUESTION ABOUT MODEL VOLUME AROUND PHYSICAL PARTS

Posted 19.01.2012, 22:09 GMT-5 Geometry, Materials Version 4.2 1 Reply

Shengan Bian Jeff
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, there,

I tried to calculate the capacitance of two parallel materials. I searched the capacitance calculations with Comsol and saw some people model a volume to contain these two materials. So I tried to create a new big block to contain them. However, I cannot change the block material to air. How can I set the model volume to contain these two materials?

It will be appericated if anyone can give me some hints

Thanks

Jeff
1 Reply Last Post 22.01.2012, 11:51 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 22.01.2012, 11:51 GMT-5
Hi

if you change your geometry after a model is fully build (topology change), you need to check all your physics, as often this changes the numbering of the domains and boundaries, and COMSOL cannot always remap them correctly without some "human" help. the new domains might also have to be added to the phyics

Could that be your issue ?

--
Good luck
Ivar
Hi if you change your geometry after a model is fully build (topology change), you need to check all your physics, as often this changes the numbering of the domains and boundaries, and COMSOL cannot always remap them correctly without some "human" help. the new domains might also have to be added to the phyics Could that be your issue ? -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content