Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
A problem occure when building subdomain in AC/DC 3D
Posted 12.12.2011, 17:41 GMT-5 Low-Frequency Electromagnetics, Geometry Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi everyone:
I am trying to build a self-designed transformer using the 3D AC/DC COMSOL. Because the whole thing contains both large scale and small scale, I built two subdomains to generate the meshes. Now the meshes works but it seems that the subdomain cannot transfer any flux to the other domains. I tried to modify the bondary conditions but it does not work. The software cannot solve the domains out of one subdomain. I think there must be something wrong with the bondary, and it is not continous. I wonder what I can do to make it continous? Thank you very much!
I am trying to build a self-designed transformer using the 3D AC/DC COMSOL. Because the whole thing contains both large scale and small scale, I built two subdomains to generate the meshes. Now the meshes works but it seems that the subdomain cannot transfer any flux to the other domains. I tried to modify the bondary conditions but it does not work. The software cannot solve the domains out of one subdomain. I think there must be something wrong with the bondary, and it is not continous. I wonder what I can do to make it continous? Thank you very much!
1 Reply Last Post 13.12.2011, 01:14 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
continuity "by default" is applied in "Geometry - Finish - Union" mode, you get discontinuous boundaries in "assembly mode".
for this to work smoothly, in v4, as for 3.5 your geometries must be made of looped "poly-lines", without gaps
--
Good luck
Ivar
continuity "by default" is applied in "Geometry - Finish - Union" mode, you get discontinuous boundaries in "assembly mode".
for this to work smoothly, in v4, as for 3.5 your geometries must be made of looped "poly-lines", without gaps
--
Good luck
Ivar