Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Adding a layer of air in a thermal actuator?
Posted 25.11.2019, 20:33 GMT-5 Electromagnetic Heating, Structural & Acoustics, MEMS & Piezoelectric Devices 0 Replies
Please login with a confirmed email address before reporting spam
I am modeling a thermal actuator and would like to account for conduction through air between the small gap of two beams however I cannot get it to converge. I'm tryied to add a layer using heat transfer in fluids, but Comsol is asking for and elastic modulus and poissons ratio.... I've included a screenshot of where I'm at. The large planar area is the air and the outline is the thermal actuator. Thank you for your time!! !
Image Link - https://ibb.co/YW66Wyf
Hello rkub
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.