Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

PROBLEM: Nonlinear solver did not converge. Rotating Machinery

Posted 24.11.2011, 09:00 GMT-5 Fluid & Heat, Studies & Solvers Version 4.1 1 Reply

Jason Castro
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate a stirring reactor, following the instructions of tutorial "Laminar Flow in a Baffled Stirred Mixer", but with some differences:
- The impeller is a turbine
- Viscosity of fluid is 0.038 Pa*s
- The angular speed is 68 rpm

My problem is that the solver did not converge, what could be happening?
The model is attached

Jason

Attachments:

1 Reply Last Post 28.11.2016, 22:17 GMT-5
COMSOL Moderator

Hello Jason Castro

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

DW
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 28.11.2016, 22:17 GMT-5
Hello,

This model will converge if you take these steps:
(1) Add boundary layer meshing to the rotor.
(2) Add boundary layer meshing to the interface of the rotating domain with the stationary domain.
(3) Add study 1 (frozen rotor study) before study 2 (time-dependent study).
(4) Converge the frozen rotor study using several values of rpm, ramping up the rpm e.g. 1, 2, 4, 8, 16, 32, 64, 68 rpm -- the desired value of rpm is 68 rev/min in the original model.
(5) Use the results of study 1 (frozen rotor) as initial conditions for study 2; to do this, go to "Values of Dependent Variables" in setup for Study 2 and set Settings: User controlled, Method: Solution, Study: Study 1 Frozen Rotor.
(6) Compute study 2 (time-dependent study).

-DW
Hello, This model will converge if you take these steps: (1) Add boundary layer meshing to the rotor. (2) Add boundary layer meshing to the interface of the rotating domain with the stationary domain. (3) Add study 1 (frozen rotor study) before study 2 (time-dependent study). (4) Converge the frozen rotor study using several values of rpm, ramping up the rpm e.g. 1, 2, 4, 8, 16, 32, 64, 68 rpm -- the desired value of rpm is 68 rev/min in the original model. (5) Use the results of study 1 (frozen rotor) as initial conditions for study 2; to do this, go to "Values of Dependent Variables" in setup for Study 2 and set Settings: User controlled, Method: Solution, Study: Study 1 Frozen Rotor. (6) Compute study 2 (time-dependent study). -DW

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content