Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Point value in 3D Geometry
Posted 23.11.2011, 05:54 GMT-5 Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am working with 3D geometry(Heat transfer module) and
i want to know the point value.
Can I define x, y, z value in results table?
Because there was a problem defining point at geomtry
I want to avoid defining point as geometry.
Can you help?
Thanks
I am working with 3D geometry(Heat transfer module) and
i want to know the point value.
Can I define x, y, z value in results table?
Because there was a problem defining point at geomtry
I want to avoid defining point as geometry.
Can you help?
Thanks
1 Reply Last Post 23.11.2011, 06:43 GMT-5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
you can define a point in the geometry (not sure if a single point is accepted, it might have to belong to a valid boundary or edge, it was so in the early V4 versions). But anyhow, you can always:
Solve, right click the Data Set and add a 3D point Data Set, give its coordinates and then "point process" (plot) the data-set resulting from this data extraction
--
Good luck
Ivar
you can define a point in the geometry (not sure if a single point is accepted, it might have to belong to a valid boundary or edge, it was so in the early V4 versions). But anyhow, you can always:
Solve, right click the Data Set and add a 3D point Data Set, give its coordinates and then "point process" (plot) the data-set resulting from this data extraction
--
Good luck
Ivar