Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

animation error

Posted 09.08.2019, 12:51 GMT-4 Electromagnetics, Low-Frequency Electromagnetics, General Version 4.3b 1 Reply

Nikhil Valsan Kulangareth
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I recieve message "An animation must contain at least two frames". What would be reason

1 Reply Last Post 05.12.2019, 08:28 GMT-5
COMSOL Moderator

Hello Nikhil Valsan Kulangareth

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Akash Kumar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 05.12.2019, 08:28 GMT-5

Dear Nikhil, In Animation---------->Animation Editing---------->Loop over--------->Select only one parameter instead of all solution. Thanks!

-------------------
Akash kumar
Dear Nikhil, In Animation---------->Animation Editing---------->Loop over--------->Select only one parameter instead of all solution. Thanks!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content