Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How can I plot the deformed boundary?

Posted 22.05.2019, 23:47 GMT-4 Structural & Acoustics, Results & Visualization Version 4.3b 0 Replies

Chanho Jeong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I kinda have a simple question. Maybe an interface issue. (I'm using 4.3b ver.) Whenever I perform a mechanical (mostly about deformation) simulation, the defromed boundary of the geometry is not clear. Especially when a composite is imbeded into another composite, it is hard to see the interface. Is there any method to keep the boundary plot not only for the initial state but also after the deformation??

Thank you.

0 Replies Last Post 22.05.2019, 23:47 GMT-4
COMSOL Moderator

Hello Chanho Jeong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content