Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Unexpected deformation when exported the result geometry
Posted 08.03.2019, 02:59 GMT-5 Computational Fluid Dynamics (CFD), Geometry, Structural Mechanics Version 5.3a 0 Replies
Please login with a confirmed email address before reporting spam
When I finished the fluid solid coupling, I tried to remesh the deformed configuration. Here comes the question, when I export the mesh of the initial time, it is supposed to be the exactly same with the original geommetry,however, it had a very slight change which baffled me for a long time. I have tried variety of ways ending up with failure.
I cannot figure it out and need your help sincerely!
Hello 智 张
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.