Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary conditions w/ Navier Stokes module

Posted 20.11.2018, 15:32 GMT-5 Computational Fluid Dynamics (CFD) 1 Reply

Stevens Paz Sánchez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am using the Navier Stokes module and am setting a Wall, Slip condition at a boundary. However, I would like to have non-zero normal velocity at this boundary, but the default is zero. Is there some way to override the default normal velocity boundary condition?

1 Reply Last Post 23.11.2018, 08:35 GMT-5
David King
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 23.11.2018, 08:35 GMT-5

I assume by normal, you mean an outward facing normal? If so you could try the leaking wall condition and specify the outward flux.

I assume by normal, you mean an outward facing normal? If so you could try the leaking wall condition and specify the outward flux.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content