Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Rotation angles for SC-cut

Posted 14.06.2011, 11:50 GMT-4 Materials Version 3.5a 3 Replies

Alexandre Clairet
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I try to simulate a SC-cut quartz resonator.
I use the "Rotation angle method" in the "Coordinate system settings" window to define the orientation but I am a bit confused about the consecutive angles. Should I write 34(x) | 0(y) | 22(z) or -34 | 0 | -22?

Thanks for your help.

Alexandre
3 Replies Last Post 13.12.2012, 04:16 GMT-5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 14.06.2011, 16:39 GMT-4
Hi

try the coordiante plot possibilities to see the final coordinate orientation. YOu need to at least load your initial conditions to get the plot polulated (no need for a full solve)

Oups sorry that applies for V4, in 3.5 its a pain to check ;), I usually defined a force vector along x,y,z in the new coordinate and checked its direction

--
Good luck
Ivar
Hi try the coordiante plot possibilities to see the final coordinate orientation. YOu need to at least load your initial conditions to get the plot polulated (no need for a full solve) Oups sorry that applies for V4, in 3.5 its a pain to check ;), I usually defined a force vector along x,y,z in the new coordinate and checked its direction -- Good luck Ivar
Alexandre Clairet
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 15.06.2011, 03:00 GMT-4
Hi Ivar,

Thanks for your help.
Hi Ivar, Thanks for your help.
Josiah Zhang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 13.12.2012, 04:16 GMT-5

Hello,

I try to simulate a SC-cut quartz resonator.
I use the "Rotation angle method" in the "Coordinate system settings" window to define the orientation but I am a bit confused about the consecutive angles. Should I write 34(x) | 0(y) | 22(z) or -34 | 0 | -22?

Thanks for your help.

Alexandre


Hi, I think the material system should be 34 | 0 | 22. I couldnt figure out why it should be so. But it works.
[QUOTE] Hello, I try to simulate a SC-cut quartz resonator. I use the "Rotation angle method" in the "Coordinate system settings" window to define the orientation but I am a bit confused about the consecutive angles. Should I write 34(x) | 0(y) | 22(z) or -34 | 0 | -22? Thanks for your help. Alexandre [/QUOTE] Hi, I think the material system should be 34 | 0 | 22. I couldnt figure out why it should be so. But it works.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content