Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Basic Resistance measurement at EC with probes

Posted 22.05.2018, 17:27 GMT-4 Electromagnetics, Low-Frequency Electromagnetics Version 5.3 1 Reply

Nic Pv
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there, Everybody keeps asking this question but still no any simple answer here or anywhere alse, How such powerful software can't measure resistance between two points on the wire like simple multi meter can do. If this is EC simulation stationary or time dependent. Can somebody show how to set up resistance measurement between two points in few clicks, without formulas or manual calculation, just want to pick up two surfaces and click "measure resistance". Thanks!

Attachments:

1 Reply Last Post 23.05.2018, 08:07 GMT-4
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 23.05.2018, 08:07 GMT-4

Nic,

You can use Terminal boundary condition to calculate resistance between two surfaces, as shown in the attached image.

Regards, Sergei

Nic, You can use Terminal boundary condition to calculate resistance between two surfaces, as shown in the attached image. Regards, Sergei

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content