Menu

Discussion Forum

New Discussion
Filtern

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error message: Ill conditioned parameter

Posted 21.04.2011, 15:38 GMT-4 RF & Microwave Engineering Version 4.1 0 Replies

SOhan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Ill-conditioned preconditioner. Increase factor in error estimate to 1433.438943104169

was the message I received when I tried to run a microwave oven model in RF module. I did get a result though.

I got the same error earlier and the error disappeared when I refined the mesh further. I tried the same this time and it doesn't seem to be working out. I am using a Iterative solver.
0 Replies Last Post 21.04.2011, 15:38 GMT-4
COMSOL Moderator

Hello SOhan

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content