Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
connecting imported stl mesh with comsol geometry for simulation
Posted 12.04.2011, 13:17 GMT-4 0 Replies
Please login with a confirmed email address before reporting spam
I have imported a mesh in stl. format to comsol and have a 3d gemetry buit in comsol. I am unable to connect both the assemblies to run heat simulation in comsol and thus to see the effect of heating by the geometry on the mesh.
Can anyone please guide as to how do i bring the two assemblies together and can then rum simulation on it.
Your Help is urgently required and i will be very grateful.
Thanking You.
I.A
Hello isshaa aarya
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.