Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coordinate system
Posted 11.04.2011, 15:30 GMT-4 Geometry Version 4.0a 2 Replies
Please login with a confirmed email address before reporting spam
When looking at a 2D drawing in Comsol v4, which directions do x,y,z refer to?
I am looking for an answer like "x is positive to the left, y is positive going upwards (north), and z is positive coming out of the page"
The reason I need x,y, AND z is because to define surface current density on a line on a 2D drawing, you must specify what it is in the x, y, z directions. So the out-of-plane direction does matter in this case
Thanks,
I am looking for an answer like "x is positive to the left, y is positive going upwards (north), and z is positive coming out of the page"
The reason I need x,y, AND z is because to define surface current density on a line on a 2D drawing, you must specify what it is in the x, y, z directions. So the out-of-plane direction does matter in this case
Thanks,
2 Replies Last Post 11.04.2011, 18:35 GMT-4
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
in 2D +X goes from left to right, +Y from botom to top (vertical up) and Z follows the right hand rule (out of the paper)
In the same register: a Boundary = an edge in 2D has a direction, shown by the arrows, the "up normal" is "counterclockwise to the left" and should point out of the enclosed surface/domain in 2D
--
Good luck
Ivar
in 2D +X goes from left to right, +Y from botom to top (vertical up) and Z follows the right hand rule (out of the paper)
In the same register: a Boundary = an edge in 2D has a direction, shown by the arrows, the "up normal" is "counterclockwise to the left" and should point out of the enclosed surface/domain in 2D
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Great! This is perfect, thanks Ivar!