Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Slip condition for moving object in fluid

Posted 23.06.2017, 14:08 GMT-4 Geometry, Mesh Version 5.2 0 Replies

Jacob Watkins
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

My model: A cylindrical probe is being dragged through an initially static fluid. The resulting disturbances and flow patterns in the fluid are of interest.

My approach: Model the deformed mesh (a consequence of the motion of the probe) with flow modules disabled. Use the deformed mesh as an input to a second simulation where the flow responds to the moving mesh (flow is enabled in this simulation while moving mesh is disabled and the solution of the first simulation is used).

My question: Is the no-slip condition valid at the edge of the probe? I.e. can I just use a moving wall boundary condition?

I suspect that the answer to this question may be a function of probe speed?
0 Replies Last Post 23.06.2017, 14:08 GMT-4
COMSOL Moderator

Hello Jacob Watkins

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content