Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Showing convergence plots during a simulation in batch mode
Posted 20.04.2017, 09:59 GMT-4 Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Chemical Reaction Engineering, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers Version 5.2a 1 Reply
Please login with a confirmed email address before reporting spam
I am using COMSOL 5.2a on Windows 7 and run my codes in batch mode using Notepad and Windows command line. By using ''-graphics'' command I can see plots of my already defined probes on screen during a simulation but I do not see convergence plot. Does anyone knows how can I see convergence plots during a simulation in batch mode?
It is possible to look at the residual figures in the log file but I believe there should be a more straight forward way to show the convergence plot easily.
Best regards,
Reza
Hello Reza Ansari Shirvan
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Hello! I am also interested to hear if this is possible, to plot convergence while solving in batch mode?