Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with meshing my geometry in the corner

Posted 10.04.2017, 23:42 GMT-4 Mesh Version 5.2a 3 Replies

Mohammad Amin Kazemi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi
Can anyone help me get my desired mesh in the corner of the curved surface found in the attachment?
This is a 3D model and I used tetrahedral meshes. As I decrease the mesh size, I still get one element in the corner. I need to get two or more.
Is there any way to do this?
Amin,

Attachments:

3 Replies Last Post 11.04.2017, 10:52 GMT-4
Mark Harradine
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 11.04.2017, 02:08 GMT-4
You could perhaps use partitioning of the geometry to force the elements to be as you would like. Maybe use the point in the corner as one of three points to define the workplane to split your part.

Mark
You could perhaps use partitioning of the geometry to force the elements to be as you would like. Maybe use the point in the corner as one of three points to define the workplane to split your part. Mark
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 11.04.2017, 09:45 GMT-4
Amin,

Attached is mesh with controlled number of elements in the corner.

Regards,
Sergei
Amin, Attached is mesh with controlled number of elements in the corner. Regards, Sergei

Attachments:

Mohammad Amin Kazemi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 11.04.2017, 10:52 GMT-4
Thank you for your replies. It worked.
Amin,
Thank you for your replies. It worked. Amin,

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content