Menu

Discussion Forum

New Discussion
Filtern

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Revolving Geometry including Properties

Posted 08.07.2009, 10:55 GMT-4 0 Replies

David Wenger Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a question concerning the "Revolve"/"Extrude"-function of Comsol. I often set up a part of the model in 2d in order to see if it works. Then I extrude/revolve it into a 3d-geometry and add some features. Unfortunately, I always lose everything I specified in 2d (materials, boundaries, even the application modes etc.). Is it possible to keep the model specified even when it is in 3d instead of 2d?

Regards

David Wenger
0 Replies Last Post 08.07.2009, 10:55 GMT-4
COMSOL Moderator

Hello David Wenger

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content